Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Basic Configuration

 

To enable the 1-Port G.SHDSL Mini-Physical Interface Module (Mini-PIM) installed on the SRX Series Services Gateway, you must configure its properties. You can perform the same configuration tasks using J-Web or the CLI. In addition, you can configure a wider variety of options that are encountered less frequently.

To perform basic perform basic configuration of the 1-Port G.SHDSL Mini-PIM and configure network interfaces for the services gateway with the CLI:

  • Verify that the 1-Port G.SHDSL Mini-PIM is installed on the services gateway:

    show chassis hardware

  • Verify the status of the interface:

    show interfaces terse

  • Assign the port an IP address:

    set interface at-1/0/0 unit 0 family inet address interface address/destination prefix

  • Add or select a security zone, for example, Zone1:

    set security zones security-zone zone1 interfaces at-1/0/0.0 host-inbound-traffic system-services all

  • Add or select a security zones for host inbound traffic protocol options:

    set security zones security-zone zone1 interfaces at-1/0/0.0 host-inbound-traffic protocols all

  • Set security policies:

    set security policies default-policy permit-all