Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Connecting to the SRX220 Services Gateway Setup Wizard

 

If you plan to use the setup wizard to configure the SRX220 Services Gateway, you must connect your management device (such as a laptop or desktop computer) to one of the built-in Ethernet ports 0/1 through 0/7 on the services gateway as shown in Figure 1. Do not use built-in Ethernet port 0/0.

Figure 1: Connecting to the Ethernet Port on an SRX220 Services Gateway
Connecting
to the Ethernet Port on an SRX220 Services Gateway

To enable communication between the management device and the services gateway, ports 0/1 through 0/7 are preconfigured with the IP address 192.168.1.1 and use DHCP to assign an IP address in the 192.168.1.0/24 network to any connected device.

To connect to the Ethernet port:

  1. Ensure that the IP address for the Ethernet port on the management device is configured in one of the following ways:
    • The IP address is assigned by DHCP.

    • The IP address is in the 192.168.1.0/24 subnetwork (but is not 192.168.1.1).

  2. Turn off the management device.
  3. Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management device.
  4. Connect the other end of the Ethernet cable to any of the built-in Ethernet ports 0/1 to 0/7 on the services gateway.

    If the services gateway has not already been powered on, power it on now.

  5. Wait until the Status LED on the front panel of the services gateway lights green.
  6. Turn on the power to the management device. The services gateway assigns an IP address to the management device within the 192.168.1.0/24 network if the management device is configured to use DHCP.
  7. To access the setup wizard, open a Web browser on the management device and enter the IP address 192.168.1.1 in the address field.Note

    The wizard works best with Mozilla Firefox version 15.x or later.