Technical Documentation

Configuring the SRX 210 Services Gateway Mini-Physical Interface Modules

To enable the Mini-Physical Interface Modules (Mini-PIMs) installed on your SRX 210 services gateway to work properly, you must configure their properties. You can configure a T1, E1, SFP, and ADSL interface using:

  • J-Web Quick configuration editor
  • CLI configuration editor

J-Web Quick configuration editor

To configure Mini-PIMs with J-Web Quick configuration editor:

  1. In the J-Web user interface, select Configuration > Quick Configuration > Interfaces.

    A list of the network interfaces present on the services gateway is displayed.

  2. To configure properties for a network interface, select the interface name and proceed with configuration.

For more information about configuring the Mini-PIMs, see the following guides:

  • JUNOS Software Interfaces and Routing Configuration Guide
  • CLI Reference for J-series Services Routers and SRX-series Services Gateways

CLI configuration editor

To configure Mini-PIMs with CLI Configuration editor:

  1. On the CLI configuration editor, use the statements in the interfaces configuration hierarchy to configure interfaces on the device as shown below:

    show interfaces <interface-name>

    Example: user@host> show interfaces ge-0/0/1.0

  2. The status information and statistics about interfaces on services gateway are displayed.

    Table 1 lists the typical interface names.

    Table 1: SRX 210 Services Gateway Interface Port Numbers

    Interface

    Port Number

    ATM-over-ADSL interface

    at-1/0/0

    T1 interface

    t1-1/0/0

    E1 interface

    e1-1/0/0

    1-Port SFP interface

    ge-1/0/0

    Gigabit Ethernet interface

    ge-0/0/0 and ge-0/0/1

    Fast Ethernet interface

    fe-0/0/2 to fe-0/0/7

For more information about configuring the Mini-PIMs, see the following guides:

  • JUNOS Software Interfaces and Routing Configuration Guide
  • CLI Reference for J-series Services Routers and SRX-series Services Gateways