Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring Static Routing

    You can use the J-Web interface to configure static routes for the QFX Series.

    To configure static routes:

    1. Select Configure > Routing > Static Routing. The Static Routing page displays details of the configured routes.

      Note: After you make changes to the configuration on this page, you must commit the changes for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes for details about all commit options.

    2. Click one:

      • Add—To configure a route. Enter information in the routing page as described in Table 1.
      • Edit—To modify an existing route. Enter information in the routing page as described in Table 1.
      • Delete—To delete an existing route.

    Table 1: Static Routing Configuration Summary



    Your Action

    Default Route 

    Default Route

    Specifies the default gateway for the switch.

    To specify an IPv4 address:

    1. Select IPv4.
    2. Type an IP address—for example,
    3. Enter the subnet mask or address prefix. For example, 24 bits represents
    Static Routes 


    Specifies the next-hop address or addresses to be used when routing traffic to the static route.

    To add an address:

    1. Click Add.
    2. In the IP address text box, enter the IP address.

      Note: If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

    3. Click OK.

    To delete a next-hop address, select it from the list and click Delete.

    Published: 2013-08-15