Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic Configuration

 

To enable the 1-Port Gigabit Ethernet small form-factor pluggable Mini-Physical Interface Module (SFP Mini-PIM) installed on the SRX Series Services Gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for this using either the J-Web interface or the CLI.

Using the J-Web Interface

To perform basic configuration of the 1-Port Gigabit Ethernet SFP Mini-PIM and to configure network interfaces for the services gateway using the J-Web interface:

  1. In the J-Web interface, select Configure>Interfaces>Ports.

    The Interfaces page is displayed and lists the network interfaces present on the services gateway, along with configuration information (if the device is configured).

  2. To configure properties for a network interface (Mini-PIM), select the interface name, and click Edit.
  3. To use the port on the Mini-PIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:Note

    The configuration settings given in the following steps are an example. The actual configuration settings might vary depending on your requirements.

    1. Select Configure>Security>Zones/Screens.
    2. Add or select a security zone other than Null; for example, Trust.
    3. For host inbound traffic, set the following:
      • Services=telnet

      • Protocols=ospf

    4. Click OK, and click Commit to apply the configuration and other pending changes (if any).
  4. To use the port on the Mini-PIM, you must also set security policies. Select the following settings:
    1. Select Configure>Security>Policy>Apply Policy.
    2. Set Policy Action: Default Policy Action=from-zone trust to-zone trust.
    3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

    For advanced configuration information, see the Junos OS Network Interfaces Configuration Guide.

Using the CLI

To perform basic configuration of the 1-Port Gigabit Ethernet SFP Mini-PIM and to configure network interfaces for the services gateway with the CLI:

Note

The configuration settings given in the following steps are an example. The actual configuration settings might vary depending on your requirements.

  • Verify that the 1-Port Gigabit Ethernet SFP Mini-PIM is installed on the device:

    show chassis hardware

    user@host > show chassis hardware

    The following is a sample output of the command (SRX240 output shown, other devices similar):

    Note

    In the example shown above, the output for the 1-Port SFP Mini-PIM appears as 1X GE SFP mPIM, and the output for the 1-Port Gigabit Ethernet SFP Mini-PIM appears as 1X GE High-Perf SFP mPIM.

  • Verify the status of the interface:

    show interfaces terse

  • Assign the port an IP address, for example:

    set interfaces ge-1/0/0 unit 0 family inet address interface address/destination prefix

  • Add or select a security zone; for example, Trust:

    set security zones security-zone trust interfaces ge-1/0/0.0 host-inbound-traffic system-services telnet

  • Add or select security zones for host inbound traffic protocol options, for example :

    set security zones security-zone trust interfaces ge-1/0/0.0 host-inbound-traffic protocols ospf

  • Set security policies:

    set security policies from-zone trust to-zone trust