Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    1-Port G.SHDSL 8-Wire Mini-Physical Interface Modules Basic Configuration

    To enable the 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module (Mini-PIM) installed on the SRX Series Services Gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for this using either the J-Web interface or the CLI.

    Using the J-Web Interface

    To perform basic configuration for the 1-Port G.SHDSL 8-Wire Mini-PIM and to configure network interfaces for the services gateway using the J-Web interface:

    1. In the J-Web interface, select Configure>Interfaces>Ports.

      The Interfaces page displays and lists the network interfaces present on the services gateway, along with configuration information (if configured).

    2. To configure properties for a network interface (Mini-PIM), select the interface name (at-1/0/0), and click Edit.
    3. To use the port on the Mini-PIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
      1. Select Configure>Security>Zones.
      2. Add or select a security zone other than Null; for example, Trust.
      3. For host inbound traffic, set the following:
        • System Services=Allow All
        • Protocols=Allow All
      4. Click OK to save changes, and click Commit to apply the configuration and other pending changes.
    4. To use the port on the Mini-PIM, you must also set security policies. Select the following settings:
      1. Select Configure>Security>Policy>Apply Policy.
      2. Set Policy Action: Default Policy Action=Permit-All.
      3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

      For more information, in the J-Web interface, select Configure>Interfaces and click Help.

    Using the CLI

    To perform basic configuration for the 1-Port G.SHDSL 8-Wire Mini-PIM and to configure network interfaces for the services gateway with the CLI:

    • Verify that the G.SHDSL interface is installed on the device:

      show chassis hardware

    • Verify the status of the interface:

      show interfaces terse

    • Assign the port an IP address:

      set interfaces at-1/0/0 unit 0 family inet address Interface address/destination prefix

    • Add or select a security zone; for example, Trust:

      set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic system-services all

    • Add or select security zones for host inbound traffic options protocols:

      set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic protocols all

    • Set security policies:

      set security policies default-policy permit-all

    See the Junos OS Network Interfaces Configuration Guide for more details.

    Published: 2012-11-27