Technical Documentation

Basic Configuration of the Quad T1/E1 GPIM

To enable the Quad T1/E1 Gigabit-Backplane Physical Interface Module (GPIM) installed on the SRX650 Services Gateway, you must configure its properties. You can perform the same configuration tasks using the J-Web interface or the CLI.

Using the J-Web Interface

To perform basic configuration for the Quad T1/E1 GPIM and configure network interfaces for the services gateway with the J-Web interface:

  1. In the J-Web interface, select Configure>Interfaces.

    The Interfaces page displays and lists the network interfaces present on the services gateway. Verify whether the interface has been configured by reviewing the information in the Configured column (yes/no).

  2. Select the interface name to edit.
  3. To use the port on the GPIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
    1. Select Configure>Security>Zones.
    2. Add or select a security zone other than Null, for example, Trust.
    3. For Host Inbound Traffic, set the following:
      • System Services=Allow All
      • Protocols=Allow All
    4. Click OK and click Commit to apply the configuration and other pending changes (if any).
  4. To use the port on the GPIM, you must also set security policies. See the following settings:
    1. Select Configure>Security>Policy>FW Policies.
    2. Set Policy Action: Default Policy Action=Permit-All.
    3. Click OK to save changes and click Commit to apply the configuration and other pending changes (if any).

For advanced configuration information, see the JUNOS Network Interfaces Configuration Guide.

Using the CLI to Configure the T1 Interface

To perform basic configuration for the Quad T1/E1 GPIM (for the T1 interface) and configure network interfaces for the services gateway with the CLI:

  • Verify that the Quad T1/E1 GPIM is installed on the services gateway:

    show chassis hardware

  • Verify the status of the interface:

    show interfaces terse

  • Assign the port an IP address:

    set interface t1-1/0/0 unit 0 family inet address Interface address/destination prefix

  • Add or select a security zone, for example, Zone1:

    set security zones security-zone zone1 interfaces t1-1/0/0.0 host-inbound-traffic system-services all

  • Add or select security zones for host inbound traffic:

    set security zones security-zone zone1 interfaces t1-1/0/0.0 host-inbound-traffic protocols all

  • Set security policies:

    set security policies default-policy permit-all

Using the CLI to Configure the E1 Interface

To perform basic configuration for the Quad T1/E1 GPIM (for the E1 interface) and configure network interfaces for the services gateway with the CLI:

  • Verify that the Quad T1/E1 GPIM is installed on the services gateway:

    show chassis hardware

  • Verify the status of the interface:

    show interfaces terse

  • Assign the port an IP address:

    set interface e1-1/0/0 unit 0 family inet address Interface address/destination prefix

  • Add or select a security zone, for example, Zone1:

    set security zones security-zone zone1 interfaces e1-1/0/0.0 host-inbound-traffic system-services all

  • Add or select security zones for host inbound traffic:

    set security zones security-zone zone1 interfaces e1-1/0/0.0 host-inbound-traffic protocols all

  • Set security policies:

    set security policies default-policy permit-all


Published: 2010-05-06