[an error occurred while processing this directive] [an error occurred while processing this directive]

Configuring the SRX650 Services Gateway Dual T1/E1 GPIM

To enable the Dual T1/E1 GPIM installed on your SRX650 services gateway, you must configure its properties. You can perform the same configuration tasks using the J-Web interface or the CLI. In addition, you can configure a wider variety of options that are encountered less frequently.

Using the J-Web Interface

To perform basic configuration for the Dual T1/E1 GPIM and configure network interfaces for the services gateway with J-Web Quick Configuration:

  1. In the J-Web user interface, select Configuration>Quick Configuration >Interfaces.

    A list of the network interfaces present on the services gateway is displayed, as shown in Figure 1. The third column indicates whether the interface has been configured.

    Figure 1: Interfaces Quick Configuration Page

    Image s032707.gif

  2. To configure properties for a network interface (GPIM), select the interface name (T1 or E1) to edit.
  3. To use the port on the GPIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
    1. Select Quick Configuration>Zones.
    2. Add or select a security zone other than null, for example, Zone1.
    3. For the Host Inbound Traffic option, set the following:
      • System Services=Allow All
      • Protocols=Allow All
    4. Click OK.
    5. Click Apply to apply the configuration and return to the J-Web Quick Configuration page.
  4. To use the port on the GPIM, you must also set security policies. Select the following settings:
    1. Select Quick Configuration>Security Policies>FW/VPN Policies.
    2. Set Policy Action: Default Policy Action=Permit-All.
    3. Click Apply to apply the configuration and return to the J-Web Quick Configuration page.

For advanced configuration information, see the JUNOS Network Interfaces Configuration Guide.

Using the CLI to Configure the T1 Interface

To perform basic configuration for the Dual T1/E1 GPIM (for the T1 interface) and configure network interfaces for the services gateway with the CLI:

set interface t1-1/0/0 unit 0 family inet address ipaddress/mask
set security zones security-zone zone1 interfaces t1-1/0/0.0 host-inbound-traffic system-services all
set security zones security-zone zone1 interfaces t1-1/0/0.0 host-inbound-traffic protocols all
set security policies default-policy permit-all

Using the CLI to Configure the E1 Interface

To perform basic configuration for the Dual T1/E1 GPIM (for the E1 interface) and configure network interfaces for the services gateway with the CLI:

set interface e1-1/0/0 unit 0 family inet address ipaddress/mask
set security zones security-zone zone1 interfaces e1-1/0/0.0 host-inbound-traffic system-services all
set security zones security-zone zone1 interfaces e1-1/0/0.0 host-inbound-traffic protocols all
set security policies default-policy permit-all


Updated: 2009-04-23

[an error occurred while processing this directive]