Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Replacing an AC Power Supply on the SRX3600 Services Gateway

 
Note

For the services gateway to meet NEBS and ETSI standards, all four AC power supplies must be Revision 09 or later. See SRX3600 Services Gateway NEBS and ETSI Compliance for more information.

Note

The same AC power supply is used in both the SRX3400 and SRX3600 Services Gateways. However, this power supply is not interchangeable with that used in the SRX1400 Services Gateway. The SRX1400 Services Gateway power supply will fit into the SRX3600 Services Gateway, but will not work properly. You can identify the SRX1400 Services Gateway power supply by the plastic air filter assembly installed over the cooling air inlet as shown in Figure 1.

Figure 1: Identifying Power Supply Types
Identifying Power Supply Types

To replace an AC power supply:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX3600 Services Gateway.
  2. Remove the power cord from the power supply.
  3. Push the tab on the right edge of the power supply to the left.
  4. Pull the power supply straight out of the chassis using the provided handle. Use one hand to support underneath the supply as you remove it.
    Figure 2: Removing an AC Power Supply
    Removing an AC Power Supply
  5. Orient the replacement power supply so that the tab is on the right side, as shown in Figure 3.
    Figure 3: Inserting an AC Power Supply
    Inserting an AC Power Supply
  6. Using both hands, slide the replacement power supply straight into the chassis until the power supply is fully seated in the chassis slot. Make sure the tab on the right edge of the power supply clicks into place. The power supply faceplate should be flush with any adjacent power supply faceplate.Note

    Be sure to have the power supply oriented correctly. The tab must be on the right and click into place when fully seated. If the power supply does not insert easily or does not become flush with the chassis, you might have inserted the power supply upside down.

  7. Attach the power cord to the power supply. If the power supply is correctly installed and functioning normally, the power supply powers up immediately. Note

    You must have an SFB and a Routing Engine installed in the services gateway for the power supply to turn on automatically.

    Note

    If you were moving this power supply from one slot to another, wait at least 60 seconds before inserting it into the new slot.

Related Documentation