Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

IN THIS PAGE

1-Port Clear Channel DS3/E3 GPIM Basic Configuration

 

To enable the 1-Port Clear Channel DS3/E3 GPIM installed on the SRX Series Services Gateway, you must configure its properties. You can perform the basic configuration tasks using the CLI. In addition, you can configure a wide variety of options that are not encountered frequently.

Using the CLI

To perform basic configuration for the 1-Port Clear Channel DS3/E3 GPIM and to configure network interfaces for the services gateway with the CLI:

  • Verify that the 1-Port Clear Channel DS3/E3 GPIM is installed on the services gateway:

    show chassis hardware

  • Verify the FPC status of the interface:

    show chassis fpc

  • Verify the PIC status:

    show chassis fpc pic-status

  • Set the DS3/E3 port mode; for example, DS3 mode:

    set chassis fpc <fpc no> pic 0 port 0 framing t3/e3

    Note

    By default, the PIC comes up in DS3 mode and the t3-x/y/z physical interface is created. The port mode chosen for t3 is IFDP_T3, and the port mode chosen for e3 is IFDP_E3.

  • Assign the port an IP address:

    set interfaces t3-3/0/0 unit 0 family inet address interface address/destination prefix

  • Assign MTU values:

    set interfaces t3-3/0/0 unit 0 family inet mtu mtu values

  • Enable/disable unframed DS3 mode; for example, unframed:

    set interfaces t3-3/0/0 t3-options unframed

  • Set encapsulation:

    set interfaces t3-3/0/0 encapsulation cisco-hdlc

  • Add or select a security zone; for example, trust:

    set security zones security-zone trust interfaces t3-3/0/0.0 host-inbound-traffic system-services all

  • Add or select security zones for host inbound traffic:

    set security zones security-zone trust interfaces t3-3/0/0.0 host-inbound-traffic protocols all

  • Set security policies:

    set security policies default-policy permit-all