16-Port QSFP+ Front Card LEDs on a QFX3008-I Interconnect Device

 

Each 16-port QSFP+ front card has two LEDs at the bottom of the module front panel that indicate front card status. Each QSFP+ port has two LEDs that indicate link status and activity. See Figure 1.

Figure 1: 16-Port QSFP+ Front Card LEDs on a QFX3008-I Interconnect Device
16-Port QSFP+ Front Card
LEDs on a QFX3008-I Interconnect Device

Table 1 describes these LEDs, their colors and states, and the status they indicate.

Table 1: 16-Port QSFP+ Front Card LEDs on a QFX3008-I Interconnect Device

LED

Color

State

Description

Status

Green

On steadily

Front card is operating normally.

Intermittent blinking

The beacon feature has been enabled on the card using the request chassis beacon command.

Amber

On steadily

Software is loading on the front card.

Blinking

Front card has failed to boot properly and needs to be reset or reinstalled. See Installing a 16-Port QSFP+ Front Card in a QFX3008-I Interconnect Device.

Power

Unlit

Off

There is no power to the front card, or the front card is not fully seated in the chassis. See Installing a 16-Port QSFP+ Front Card in a QFX3008-I Interconnect Device.

Green

On steadily

Front card is powered on.

Amber

Blinking

Front card is offline.

Table 2 describes the QSFP+ port LEDs.

Table 2: 16-Port QSFP+ Front Card Port LEDs on a QFX3008-I Interconnect Device

LED

Color

State

Description

Link/Activity

Unlit

Off

No link is established, there is a fault, or the link is down.

Green

On steadily

A link is established, but there is no link activity.

Flickering

A link is established, and there is link activity.

Status

Unlit

Off

No transceiver is installed in the port, the port is configured for a different interface, or the transceiver is not supported.

Green

On steadily

A transceiver is installed in the port.