[an error occurred while processing this directive] [an error occurred while processing this directive]

SRX650 Services Gateway Power Specifications and Requirements

The AC power system electrical specifications for the SRX650 services gateway are listed in Table 1.

Table 1: Power Supply Electrical Specifications for the SRX650 Services Gateway

Power Requirement

Specification

AC input voltage

100 to 240 VAC

AC input line frequency

50 to 60 Hz

AC system current rating

10 to 5 A

Warning: The AC power cord for the services gateway is intended for use with the services gateway only and not for any other use.

Note: In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in length, to comply with National Electrical code (NEC) Section 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3).

Table 2 provides power cord specifications, and Figure 1 depicts the plug on the AC power cord provided for each country or region.

Table 2: AC Power Cord Specifications

Country

Electrical Specification

Plug Standards

Australia

250 VAC, 10 A, 50 Hz

AS/NZ 3112-1993

China

250 VAC, 10 A, 50 Hz

GB2099.1 1996 and GB 1002 1996 (CH1-10P)

Europe (except Italy and United Kingdom)

250 VAC, 10 A, 50 Hz

CEE (7) VII

Italy

250 VAC, 10 A, 50 Hz

CEI 23-16/VII

Japan

125 VAC, 12 A, 50 or 60 Hz

JIS 8303

North America

125 VAC, 10 A, 60 Hz

NEMA 5-15

United Kingdom

250 VAC, 10 A, 50 Hz

BS 1363A

Figure 1: AC Plug Types

Image g001892.gif

Note: Power cords and cables must not block access to services gateway components or drape where people may trip on them.


Updated: 2009-04-23

[an error occurred while processing this directive]