[an error occurred while processing this directive][an error occurred while processing this directive]

JCS1200 Management Module Connectors and LEDs

Figure 1 shows the input and output connectors on the management module.

Figure 1: JCS1200 Management Module Input and Output Connectors

Image dw1as035.gif

Figure 2 shows the location of LEDs and controls on the management module.

Figure 2: JCS1200 Management Module LEDs and Controls

Image dw1as030.gif

The management module consists of the following components:

  • Serial connector—Use this connection to configure and manage the JCS1200 components over a serial line through the management module CLI. This connector provides local access to the CLI and any Routing Engine. For example, you can connect a notebook computer to the serial connector and a terminal emulator program to configure the IP addresses, user accounts, and other management settings through the CLI user interface. See the JUNOS Protected System Domain Configuration Guide for more information.
  • Video connector—The video connector is not supported.
  • Console (Ethernet) connector—Use this connector for a remote Ethernet connection to a network management station on the network.
  • Two USB ports for mouse and keyboard—The USB ports are not supported.
  • Reset button—When you press this button, the blowers operate at full speed while the management module is initializing.

    The reset button provides the following functions:

    • Press and release the reset button to restart the management module.
    • Press and hold the reset button for 8 seconds to restore the management module to factory default settings.
  • LEDs—There are five LEDs on the management module that provide status information about the management module and remote management connection. Table 1 describes the functions of these LEDs (see Figure 2).

Table 1: JCS1200 Management Module LEDs

Name

Color

State

Description

Power-on

Green

On steadily

The management module has power.

Active

Green

On steadily

The management module is actively controlling the JCS1200 platform. Only one management module actively controls the JCS1200 platform. If two management modules are installed in the JCS1200 platform, this LED is lit on only one module.

Management module error

Amber

On steadily

An error has been detected in the management module. When this LED is lit, the JCS1200 system error LED is also lit on the alarm panel.

Ethernet Link (LINK)

Green

On steadily

There is an active connection through the Ethernet port to the network.

Ethernet activity (TX/RX)

Green

Flashing

There is activity through the port over the network link.


Published: 2010-01-25

[an error occurred while processing this directive]