Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Tools and Parts Required for Replacing T1600 Hardware Components

 

To replace hardware components, you need the tools and parts listed in Table 1.

Table 1: Tools and Parts Required for Component Replacement

Components

Tool or part

All

Electrostatic discharge (ESD) grounding wrist strap

AC power supply

Three-phase delta AC power supply or three-phase wye AC power supply

Phillips (+) screwdrivers, number 2 to access the metal AC wiring compartment

1/4-in. slotted screwdriver to attach the ground wire and input terminal wires of the AC power cord.

Air filter (front or rear)

Phillips (+) screwdrivers, numbers 1 and 2

CIP

Phillips (+) screwdrivers, numbers 1 and 2

Craft interface

Phillips (+) screwdrivers, numbers 1 and 2

DC power supply

Three-input 240-A DC power supply, four-input 240-A DC power supply, or six-input DC power supply

Phillips (+) screwdrivers, numbers 1 and 2

7/16-in. (11 mm) nut driver

Caution: You must use an appropriate torque-controlled tool to tighten the nuts. Applying excessive torque damages the terminal studs and the power supply. The absolute maximum torque that may be applied to this nut is 45 lb-in. (5.0 Nm).

Flashlight

Nonconductive sharp object

DC power supply cable

7/16-in. (11 mm) nut driver

Caution: You must use an appropriate torque-controlled tool to tighten the nuts. Applying excessive torque damages the terminal studs and the power supply. The absolute maximum torque that may be applied to this nut is 45 lb-in. (5.0 Nm).

Fan tray (front or rear)

Phillips (+) screwdrivers, numbers 1 and 2

FPC

Phillips (+) screwdrivers, numbers 1 and 2

Blank panel (if component is not reinstalled)

Electrostatic bag or antistatic mat

PIC

Phillips (+) screwdrivers, numbers 1 and 2

Rubber safety cap for fiber-optic PICs or fiber-optic PIC cables

Flat-blade (–) screwdriver for Type 1 PICs

Electrostatic bag or antistatic mat

Blank panel (if component is not reinstalled)

Routing Engine

Phillips (+) screwdrivers, numbers 1 and 2

Electrostatic bag or antistatic mat

Blank panel (if component is not reinstalled)

Serial cable to AUXILIARY or CONSOLE Routing Engine port

Flat-blade (–) screwdriver

T1600-SIB

Phillips (+) screwdrivers, numbers 1 and 2

Electrostatic bag or antistatic mat

Blank panel (if component is not reinstalled)

SCG

Phillips (+) screwdrivers, numbers 1 and 2

T-CB or LCC-CB

Phillips (+) screwdrivers, numbers 1 and 2

Electrostatic bag or antistatic mat

Blank panel (if component is not reinstalled)