TX Matrix Plus TXP-F13-3D SIB LEDs
The TXP-F13-3D status LEDs (Figure 1) are located below the SIB button. Table 1 describes the functions of
these LEDs.
Table 1: TXP-F13-3D SIB LEDs
Label | Color | State | Description |
|---|---|---|---|
| Green | On steadily | TXP-F13-3D SIB is in active mode and actively passing traffic. |
– | Off | TXP-F13-3D SIB is either offline or not actively passing traffic. | |
| Green | On steadily | TXP-F13-3D SIB is functioning normally. |
– | Off | TXP-F13-3D SIB is offline or not seated properly. | |
| Red | On steadily | TXP-F13 SIB-3D has failed. |
– | Off | No faults have been detected for the TXP-F13-3D SIB. |
The port LEDs are located beneath the ports. Table 2 describes the functions of these LEDs.
Table 2: TXP-F13-3D SIB Port LEDs
Label | Color | State | Description |
|---|---|---|---|
| Green | On steadily | The link between the TXP-F13-3D SIB port and the TXP-LCC-3D SIB port has been established successfully. |
Blinking | The link between the TXP-F13-3D SIB port and the loopback connector has been established successfully. | ||
Yellow | On steadily | The link is being established. | |
Blinking | The switching plane cable might be connected to either the wrong TXP-LC-3D SIB port or wrong TXP-FI3-3D port. | ||
Red | On steadily | The link between the TXP-F13-3D SIB port and the TXP-LCC-3D SIB port failed. There might be a hardware problem, or the fiber-optic port or cable might need to be cleaned. | |
– | Off | The cable is not connected on both sides, or either the TXP-F13-3D SIB or TXP-LCC-3D SIB is powered off. | |
| Green | On steadily | Full optical power is being received. |
Yellow | On steadily | Diminished optical power is being received. The switching plane cable or the switching plane port might need cleaning, or the cable might be damaged. | |
Red | Off | Optical power has crossed operating thresholds. The switching plane cable is not connected to the TXP-FI3-3D SIB port, or not connected to the TXP-LCC-3D SIB port. If the cable is connected on both sides, the cable might be cut. | |
Off | - | No optical power is detected. Cable is damaged or absent. |