Gigabit Ethernet IQ2 PICs with SFP (M320 Router) Figure 1: 4-Port Gigabit Ethernet IQ2 PIC (Type 1) Figure 2: 8-Port Gigabit Ethernet IQ2 PIC (Type 2)
Figure 3: 8-Port Gigabit Ethernet IQ2 PIC (Type 3) Software release
4-port: Junos OS Release 7.6R3 and later (Type 1)
8-port: Junos OS Release 7.6R2 and later (Type 2)
Note:
M320 routers support no more than three 8-port Ethernet
IQ2 PICs in an FPC2. Table 1 describes
which PICs can be installed in the fourth slot of the FPC2.
8-port: Junos OS Release 8.2 and later (Type 3)
For information on which FPCs support these PICs, see M320 PIC/FPC Compatibility .
Description
Hardware features
Software features
Intelligent handling of oversubscribed traffic for the
Type 1 and Type 2 PICs
Optical diagnostics and related alarms
Quality of service (QoS) per channel: weighted round-robin
(WRR), random early detection (RED), weighted random early detection
(WRED)
Virtual Router Redundancy Protocol (VRRP) support
Hierarchical shaping
Fine-grained queuing and shaping per logical interface
at both ingress and egress
802.1q virtual LANs (VLANs)
VLAN stacking and rewriting
Channels defined by two stacked VLAN tags
Multiple tag protocol identifiers (TPID) support
IP service for nonstandard TPID and stacked VLAN tags
802.1p rewrite per channel
Flexible mapping of channels and scheduler resources at
both ingress and egress
Flexible Ethernet encapsulation
MAC learning, policing, accounting, and filtering
Cables and connectors
You can install any transceiver supported by the PIC.
Note:
Do not install SONET/SDH SFPs in the Gigabit Ethernet
port. The port will not recognize the SFP.
Fiber-optic small form-factor pluggable transceivers (SFPs):
Duplex LC/PC connector (Rx and Tx)
1000Base-LH (model number: SFP-1GE-LH)
1000Base-LX (model number: SFP-1GE-LX)
1000Base-SX (model number: SFP-1GE-SX)
Optical interface specifications—see the Hardware
Compatibility Tool at https://apps.juniper.net/hct/
1000Base-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—see
the Hardware Compatibility Tool at https://apps.juniper.net/hct/
Copper transceivers:
Connector: Four-pair, Category 5 shielded twisted-pair
connectivity through an RJ-45 connector
1000Base-T (model number: SFP-1GE-T)
Copper interface specifications—see the Hardware
Compatibility Tool at https://apps.juniper.net/hct/
LEDs
OK or Status LED, one tricolor:
Off—PIC is offline and it is safe to remove it from
the router.
Green—PIC is operating normally.
Yellow—PIC is initializing.
Red—PIC has an error or failure.
APP LED, one bicolor:
Port LEDs, one per port:
Table 1: PICs Supported
in Fourth Slot of FPC2 with Three 8-Port Ethernet IQ2 PICs on M320
Routers
PIC Name
PIC Model Number
Gigabit Ethernet, 2-port SFP
PB-2GE-SFP
Gigabit Ethernet, 4-port SFP
PB-4GE-SFP
Gigabit Ethernet IQ, 2-port SFP
PB-2GE-SFP-QPP
SONET/SDH OC12c/STM4, 4-port with multimode transceivers
installed
PB-4OC12-SON-MM
SONET/SDH OC12c/STM4, 4-port with single-mode intermediate
reach transceivers installed
PB-4OC12–SON-SMIR
SONET/SDH OC48/STM16, 1-port SFP
PB-1OC48–SON-SFP
Tunnel Services
PB-TUNNEL