10-Gigabit Ethernet MIC with SFP+ (10 Ports)

 
Figure 1: 10-Gigabit Ethernet MIC with SFP+
10-Gigabit Ethernet MIC with SFP+

Software release

  • Junos 12.3 and later

Description

  • Ten 10-Gigabit Ethernet ports

  • Power requirement: 0.62 A @ 48 V (29.8 W)

  • Weight: 1.54 lb (0.70 kg)

  • Model number: MIC3-3D-10XGE-SFPP

  • Name in the CLI: 3D 10xGE SFPP

Hardware features

  • High-performance throughput on each port at speeds up to 10 Gbps

  • Supports 10 SFP+ pluggable optic ports

  • Voltage Sequencer for local voltage sequence control and monitoring

  • LAN-PHY mode at 10.3125 Gbps

  • WAN-PHY mode at 9.95328 Gbps

  • Maximum transmission units (MTUs) of up to 9192 bytes

Software features

  • Configurable LAN-PHY and WAN-PHY mode options per port

  • Synchronous Ethernet support

  • Optical diagnostics and related alarms

  • Virtual Router Redundancy Protocol (VRRP) support

  • IEEE 802.1Q virtual LANs (VLANs) support

  • Remote monitoring (RMON) EtherStats

  • Source MAC learning

  • MAC accounting and policing—Dynamic local address learning of source MAC addresses

  • Flexible Ethernet encapsulation

  • Multiple tag protocol identifiers (TPID)

Cables and connectors

Tip: You can use the Hardware Compatibility Tool to find information about the pluggable transceivers supported on your Juniper Networks device.

The list of supported transceivers for the MX Series is located at https://pathfinder.juniper.net/hct/category/#catKey=100001&modelType;=All&pf;=MX+Series.

Note: SFPP-10GE-ZR has a commercial temperature rating and is not NEBS compliant when plugged into the 10-Gigabit Ethernet MIC with SFP+. If the ambient air temperature exceeds 40 degrees C, the software disables the transmitter, which takes the optical transceiver offline.

Note: SFPP-10G-DT-ZRC2 is not NEBS compliant when plugged into the MIC3-3D-10XGE-SFPP MIC. If the ambient air temperature exceeds 40 degrees C, Junos OS disables the transmitter, which takes the optical transceiver offline.

LEDs

OK/FAIL LED, one bicolor:

  • Green—MIC is functioning normally.

  • Red—MIC has failed.

LINK LED, one per SFP+ port:

  • Off—No link.

  • Green—Link is up.

  • Yellow—Link is disabled.

The ports are labeled:

  • Port [0] to Port [9]

Note

The MIC3-3D-10XGE-SFPP MIC has one logical PIC. When the MIC is installed in slot 0 of an MPC the PIC number is 0, and when the MIC is installed in slot 1 of an MPC the PIC number is 2. For example, when the MIC is installed in slot 3 of the MX960 router, in slot 1 of the MPC, the interfaces are numbered ge-3/2/0 through ge-3/2/9.