Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

MX2010 Component LEDs on the Craft Interface

 

MX2010 Host Subsystem LEDs and Buttons on the Craft Interface

Each host subsystem has three LEDs, located in the upper middle of the craft interface, that indicate its status. The LEDs labeled RE0 show the status of the Routing Engine on the CB-RE in slot 0. The LEDs labeled RE1 show the status of the Routing Engine on the CB-RE in slot 1. Table 1 describes the functions of the host subsystem LEDs.

Table 1: Host Subsystem LEDs on the Craft Interface

Label

Color

State

Description

MASTER

Green

On steadily

Host is functioning as the master.

ONLINE

Green

On steadily

Host is online and is functioning normally.

OFFLINE

Red

On steadily

Host is installed but the Routing Engine on the CB-RE is offline.

Off

Host is not installed.

When placing the CB-RE offline, the Routing Engine goes offline. The Routing Engine gets powered by the Control Board.

MX2010 Power Supply Module LEDs on the Craft Interface

Each Power Supply Module (PSM) has one bicolor LED on the craft interface that indicates its status. The LEDs, labeled 0 through 8, are located on the upper left of the craft interface next to the PSM label. Table 2 describes the functions of the PSM LEDs on the craft interface.

Table 2: Power Supply Module LEDs on the Craft Interface

Label

Color

State

Description

PSM

Green

On steadily

PSM is functioning normally.

Red

On steadily

PSM module has failed or power input has failed.

MX2010 Line-Card LEDs and Buttons on the Craft Interface

Each line card (MPC) has one bicolor LED on the craft interface that indicates its status. The LEDs, labeled 0 through 9, are located along the bottom of the craft interface. Table 3 describes the functions of the LEDs.

Table 3: Line-Card LEDs on the Craft Interface

Label

Color

State

Description

OK

Green

On steadily

Line card functioning normally.

Blinking

Line card is transitioning online or offline.

Off

The slot is not online.

FAIL

Red

On steadily

Line card has failed.

There are ten push buttons located next to each of the line cards on the craft interface. These buttons are used to place the line cards online or offline. When a line card is inserted into an adapter card, and installed into the MX2010 router, the online/offline buttons can turn both cards on or off.

Note

When installing an adapter card without the line card, the online/offline buttons have no affect.

MX2010 SFB LED and Buttons on the Craft Interface

Each SFB has one tricolor LED on the craft interface that indicates its status. The SFB LED, labeled 0 through 7, are located along the bottom of the craft interface. Table 4 describes the functions of the SFB LED.

Table 4: SFB LED on the Craft Interface

Label

Color

State

Description

OK

Green

On steadily

SFB functioning normally.

Blinking

SFB is transitioning online or offline.

Off

The slot is not online.

FAIL

Red

On steadily

SFB has failed.

There are eight push buttons located next to each of the SFBs on the craft interface. These buttons are used to place the SFBs online or offline.

MX2010 Fan Tray LEDs on the Craft Interface

The fan tray LEDs, labeled 0 through 3, are located on the top middle of the craft interface. Table 5 describes the functions of the fan tray LEDs.

Table 5: Fan LEDs on the Craft Interface

Label

Color

State

Description

FAN TRAY

Green

On steadily

Fan is functioning normally.

Red

On steadily

Fan in a fan tray has failed.

Fan tray has failed.