Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    M40e Craft Interface Alarm LEDs and Controls

    Two large alarm LEDs are located at the upper left of the craft interface (see M40e Craft Interface Description). The circular red LED lights to indicate a critical condition that can result in a system shutdown. The triangular yellow LED lights to indicate a less severe condition that requires monitoring or maintenance. Both LEDs can be lit simultaneously.

    A condition that causes an LED to light also activates the corresponding alarm relay contact on the connector interface panel (CIP), as described in M40e Connector Interface Panel (CIP) Description. The LCD on the craft interface reports the cause of the alarm, as described in M40e Craft Interface LCD Description.

    To deactivate red and yellow alarms, press the button labeled ACO/LT (for “alarm cutoff/lamp test”), which is located to the right of the alarm LEDs. Deactivating an alarm turns off both LEDs and deactivates the device attached to the corresponding alarm relay contact on the CIP. However, the LCD continues to report the alarm message until you clear the condition that caused the alarm.

    Table 1 describes the alarm LEDs and alarm cutoff button in more detail.

    Table 1: Alarm LEDs and Alarm Cutoff/Lamp Test Button

    Shape

    Color

    State

    Description

    Image g009002.gif

    Red

    On steadily

    Critical alarm LED—Indicates a critical condition that can cause the router to stop functioning. Possible causes include component removal, failure, or overheating.

    Image g009003.gif

    Yellow

    On steadily

    Warning alarm LED—Indicates a serious but nonfatal error condition, such as a maintenance alert or a significant increase in component temperature.

    Image g009001.gif

    Alarm cutoff/lamp test button—Deactivates red and yellow alarms. Causes all LEDs on the craft interface to light (for testing purposes), when pressed and held.


    Published: 2010-10-28