TX Matrix Plus TXP-CIP LEDs

Three LEDs—ACTIVE, OK, FAIL—indicate the status of the TXP-CIP (Table 1).

Table 1: TXP-CIP LEDs

Label	Color	State	Description
`ACTIVE`	Green	On steadily	TXP-CIP is in active mode and actively passing traffic to a line-card chassis (LCC).
`ACTIVE`	–	Off	TXP-CIP is not actively passing traffic to a line-card chassis (LCC).
`OK`	Green	On steadily	TXP-CIP is functioning normally.
`OK`	–	Off	TXP-CIP is offline, or is not seated properly, or is not receiving power from the power supply.
`FAIL`	Yellow	On steadily	TXP-CIP has failed.
`FAIL`	–	Off	No faults have been detected for the TXP-CIP.

Each control plane port on the TXP-CIP has two LEDs that indicate the status of the link. Other ports are reserved for future use.

Table 2: TXP-CIP Port LEDs

Port	Label	Color	State	Description
`LCC CTRL PLANE` ports `0` through `15` Reserved ports `16` and `17`	`ACT`	Green	Blinking	Traffic is present. There is activity on the port.
	`ACT`	–	Off	There is no activity on the port.
	`SPEED`	Green	On steadily	High-speed link (1G)
		Green	On steadily	High-speed link (1G)
		Yellow	On steadily	Low-speed link (10/100M)
		–	Off	The TXP-CIP is not powered on or the port is not connected.
`SFC CTRL PLANE` ports `XGE0` through `XGE4`	`ACT`	–	–	Note: These ports are reserved for future use.
`SFC CTRL PLANE` ports `XGE0` through `XGE4`	`LINK`	–	–	Note: These ports are reserved for future use.