SRX550 Services Gateway Back Panel
Figure 1 shows the back panel of the SRX550 Services Gateway.

Table 1 describes the components on the back panel of the SRX550 Services Gateway with reference to Figure 1.
Table 1: SRX550 Services Gateway Back Panel Components
Number | Component | Location | Description | Usage |
---|---|---|---|---|
1 | Two power supply slots. Each power supply contains a power cord outlet. One 645 W AC power supply is provided with the services gateway. | Left side of back panel | The power supply provides power to the services gateway and its components. When the services gateway is equipped with the two power supply option, they work together to provide redundancy and load-sharing. The following power supplies are available:
| Power supplies are hot-swappable and support single- or dual-redundant power supply versions. If you need to power off the services gateway after it finishes booting, first use the CLI to halt the device. |
2 | ACE Slot | Top center of the back panel | Note: This slot is not used. | |
3 | Grounding point | Left side of the back panel | Contains two M4 screws that you use to connect the grounding cable to the services gateway chassis. | Connects the services gateway chassis to earth ground. |
4 | Storage slot | Center of the back panel, lower edge | Slot where you can install an extra data storage device. | Supplements the data storage capacity of the services gateway. |
5 | Electrostatic discharge (ESD) outlet | Right side of the back panel | Connector for an ESD wrist band. | While working on the services gateway, use the ESD outlet to plug in an ESD grounding strap to prevent any damage to the services gateway. |
6 | Air filter cover | Right of the back panel | Provides access to the optional air filter. Note: The air filter is not currently orderable. | The optional air filter helps keep the services gateway and its components free from dust particles. The air filter is hot-swappable. Note: The air filter is required for NEBS compliance. |