SRX110 Services Gateway Built-In Interfaces
Table 1 summarizes
the interface ports supported on the SRX110 Services Gateway.
Table 1: SRX110 Services Gateway Built-In Hardware Interfaces
Interface | Specification | Description |
|---|
Fast Ethernet | Consist of eight fixed ports Are labeled as port 0/0 to port 0/7 on the front panel Provide link speeds of 10/100 Mbps Operate in full-duplex and half-duplex modes Support flow control Support autonegotiation Support autosensing
| The Fast Ethernet ports can be used: To provide LAN connectivity to hubs, switches, local servers,
and workstations. To forward incoming data packets to the device. To receive outgoing data packets from the device.
|
Universal Serial Bus (USB) | | The USB port can be used: To support a USB storage device that functions as a secondary
boot device in case of internal flash memory device failure on startup
(if the USB storage device is installed and configured). Note:
You must install and configure the USB storage device
on the USB port to use it as a secondary boot device. Additionally,
the USB device must have Junos OS installed. To provide the USB interfaces that are used to communicate
with many types of USB storage devices supported by Juniper Networks.
|
Console | | The console port can be used: To provide the console interface. To function as a management port for logging in to a device
directly. To configure the device using the CLI.
|
Integrated VDSL2 interface | | The VDSL2 port can be used to provide LAN and WAN functionality,
along with connectivity to various media types. |
3G USB modem | The 3G-WAN USB port on the rear side uses a USB modem
extension cable to support the external 3G USB modem. | The 3G USB modem provides wireless connectivity. |
