Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring EVPN Multi-homing

 

To achieve network redundancy and load balancing, OpenStack nodes can be connected to more than one leaf switches that are capable of VXLAN-EVPN network. Juniper ML2 VXLAN-EVPN driver plug-in provisions the multi-homed peer devices with an identical Ethernet Segment Identification (ESI) number and identical VLAN, VNI encapsulation details. This enables EVPN multi-homing functionality on the device.

OpenStack nodes can utilize all the multi-homing feature enabled uplinks to send traffic. This provides load balancing and redundancy in case of any failures. The uplink interface must be an aggregated interface.

Figure 1: EVPN Multi-homing
EVPN Multi-homing

If more than one device connection is added for a particular OpenStack node using the jnpr_switchport_mapping command, the node is considered as multi-homing enabled. The interface must be an Aggregated Ethernet interface. This triggers an ESI ID generation and configures it to the aggregated switch interfaces.

Supported Devices and JUNOS Version

EX, QFX, SRX, and vSRX series devices

Configuration of ML2 VXLAN EVPN plug-in is a prerequisite for this plug-in. For more details on configuring the ML2 VXLAN EVPN plug-in, refer to Configuring ML2 VXLAN Plug-in with EVPN.

Additionally, the jnpr_switchport_mapping command creates the required physical topology name that is derived from the ESI ID and the bridge mapping details based on the topology inputs.

To update the configuration details:

  1. Update the configuration details in the Open vSwitch Agent configuration file of the OpenStack nodes to which the switch is connected:
    admin@controller:~$ jnpr_switchport_mapping add -H 10.206.44.116 -n eth3 -s 10.206.44.50 -p ae2
  2. Update the physical_topology name with VLAN ranges in the neutron ML2 plug-in configuration file ml2_conf.ini as follows:
  3. To verify whether the EVPN multi-homing plug-in is functioning properly, restart your neutron server, create networks, and VMs associated to the networks. The multi-homing enabled VMs are reachable when a redundant link is disabled.