Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

1-Port SFP Mini-Physical Interface Module Key Features

 

The 1-Port small form-factor pluggable Mini-Physical Interface Module (SFP Mini-PIM) has the following key features:

  • Enables you to install and remove transceivers without powering down the device

  • Provides real-time visual status of connectivity and traffic flows

  • Provides Link Up/Down alarm

  • Supports the following transceiver types:

    • 1000BASE-SX

    • 100BASE-LX

    • 1000BASE-LX10

    • 100BASE-FX

    • 1000BASE-T

    • 1000BASE-LH (ZX)

    • Tri-Rate 10/100/1000BASE-T, Copper Transceiver

    • 1000BASE-BX10, at 10 km (TX1310 nm / RX1490 nm)

    • 1000BASE-BX10, at 10 km (TX1310 nm / RX1550 nm)

    • 1000BASE-BX10, at 10 km (TX1490 nm / RX1310 nm)

    • 1000BASE-BX10, at 10 km (TX1550 nm / RX1310 nm)

    • 1000BASE-BX, at 40 km (TX1310 nm / 1550 nm)

    • 1000BASE-BX, at 40km (TX1550 LC nm / RX1310 nm)

    • 100Base-BX Fast Ethernet Optics, at 20 km (TX 1310 nm / RX 1550 nm)

    • 100Base-BX Fast Ethernet Optics, at 20 km (TX 1550 nm / RX 1310 nm)

Note

The 1-Port SFP Mini-PIM with Ethernet connector provides 1000-Mbps link speed. Actual bandwidth is limited to 100 Mbps.

Caution

If you face a problem running a Juniper Networks device that uses a third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help you diagnose the source of the problem. Your JTAC engineer might recommend that you check the third-party optic or cable and potentially replace it with an equivalent Juniper Networks optic or cable that is qualified for the device.