Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    2-Port XFP 10-Gigabit Ethernet I/O Card

    The SRX3K-2XGE-XFP adds two ports for 10-gigabit Ethernet traffic from fiber interface media. To use fiber interface media, install 10-gigabit small form-factor pluggable (XFP) transceivers on the desired ports.

    Figure 1 shows the 2-Port XFP 10-Gigabit Ethernet IOC. Ports are numbered from left to right, 0 through 1.

    Figure 1: 2-Port XFP 10-Gigabit Ethernet I/O Card

    2-Port XFP 10-Gigabit Ethernet
I/O Card
    • If a CFM slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the device.
    • The ONLINE button on the IOC does not perform any function and is currently not supported.

    LEDs on the faceplate of the IOC indicate port status and connectivity. Table 1 describes the 2-Port XFP 10-Gigabit Ethernet IOC LEDs.

    Table 1: LED Indicators on the 2-Port XFP 10-Gigabit Ethernet I/O Card

    Label

    Color

    Status

    Indicated Behavior

    SERVICE

    Green

    On steadily

    The IOC is mapped to the Network and Service Processing Card (NSPC) and is available to carry Ethernet traffic.

    Amber

    On steadily

    The IOC is not mapped to the NSPC and is not available to carry Ethernet traffic.

    Unlit

    Off

    The IOC is administratively disabled but is mapped to the NSPC.

    OK/FAIL

    Green

    On steadily

    The IOC is operating normally.

    Green

    Blinking

    The IOC is preparing for a hot-swappable event:

    • IOC is being Inserted: power up, booting, initialization.
    • IOC is being removed: shut down by chassis management software.

    Red

    On steadily

    The IOC has failed and is not operating normally.

    Unlit

    Off

    The IOC is offline and can be safely removed.

    Published: 2011-10-19