[an error occurred while processing this directive] [an error occurred while processing this directive]

Preparing the SRX 210 Services Gateway for Desk-Mount Installation

You can mount an SRX 210 services gateway on a desk or other level surface horizontally or vertically. The four rubber feet attached to the chassis provide stability.

Before mounting an SRX 210 services gateway on a desk or other level surface:

  • Verify that the site meets the requirements described in Site Preparation Checklist for the SRX 210 Services Gateway.
  • Place the desk in its permanent location, allowing adequate clearance for airflow and maintenance, and secure it to the building structure.
  • Remove the services gateway chassis from the shipping carton. For unpacking instructions, see Unpacking the SRX 210 Services Gateway.
  • If you are mounting the services gateway horizontally on a desk, ensure that the chassis is attached with the rubber feet. If you are mounting the device vertically on the desk, make sure that the following parts are available in your vertical desk-mounting kit for the SRX 210 services gateway:
    • Vertical stand
    • Screws

Note: The vertical desk-mounting kit is not shipped with the device.

[an error occurred while processing this directive]