Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

T1600 Craft Interface LCD and Navigation Buttons

 

A four-line LCD is located in the craft interface, along with six navigation buttons. The LCD operates in two modes:

  • LED idle mode

  • LED alarm mode

During normal operation, the LCD operates in idle mode and reports current status information, as shown in Figure 1.

Figure 1: LCD in Idle Mode
LCD in Idle Mode

The lines in the display report the following information:

  • First line—Router name.

  • Second line—Length of time the router has been running, reported in the following form:

  • Third and fourth lines—Status messages, which rotate at 2-second intervals. Some conditions, such as removal or insertion of a system component, can interrupt the messages.

To add a message that alternates every 2 seconds with the default status messages, use the set chassis display message command. For more information, see set chassis display message.

When a red or yellow alarm occurs, the LCD switches to alarm mode and reports the alarm condition, as shown in Figure 2.

Figure 2: LCD in Alarm Mode
LCD in Alarm
Mode

The lines in the display report the following information:

  • First line—Router name.

  • Second line—Number of active alarms.

  • Third and fourth lines—Individual alarm messages, with the most severe condition shown first. The prefix on each line indicates whether the alarm is a red (R) or yellow (Y) alarm.