Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

SRX1400 Services Gateway Chassis Slots

 

The SRX1400 Services Gateway chassis has seven front panel slots for various modules.

Figure 1 shows the slot label guide printed in the lower left corner of the front panel. This guide shows the names for all of the front panel slots.

Figure 1: SRX1400 Services Gateway Front Panel Slot Label Guide
SRX1400 Services Gateway
Front Panel Slot Label Guide

Table 1 describes the different slots and their functions.

Table 1: SRX1400 Services Gateway Chassis Slots

Slot

Description

CFM slots 1 and 3

The CFM slots 1 and 3 are normally combined to accommodate the double-wide NSPC. However, you can also use these slots separately, and install an NPC in CFM slot 1 and an SPC in CFM slot 3.

CFM slot 2

CFM slot 2 can be left empty, or can be used to install an IOC or NP-IOC for additional interface ports, or an SPC to add services processing capacity.

RE

Slot RE is the dedicated slot for the Routing Engine of the services gateway.

0

Slot 0 is the dedicated slot for the SYSIOC of the services gateway. This module provides fixed I/O ports for the base system and is an important element of the data plane.

P0

Slot P0 is the slot for the primary power supply of the services gateway. You must install either an AC power supply or a DC power supply in the slot.

P1

Slot P1 is the slot for a redundant power supply that provides power to the services gateway if the primary power supply fails. You can leave this slot empty, or you can use it to install either an AC power supply or a DC power supply. The power supply must be of the same type (AC or DC) as the power supply installed in slot P0.