Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

T1600 Rear Cable Management System Description

 Note

The rear cable management system is not needed for standalone T1600 routers with T1600-SIBs and T-CBs.

For T1600 routers connected to a TX Matrix Plus router, you can use the optional rear cable management system to organize, support, and provide strain relief for the cables connected to the TXP-T1600 or TXP-LCC-3D SIBs, and the cables connected to the LCC-CBs. The rear cable management system consists of one cable management arm. The cables are routed to the left side of the T1600 router, and then toward the top of the chassis, where you can route the cables to the TX Matrix Plus router. The cable management system adds 9.5 in. (24.1 cm) to the depth of the T1600 chassis, and 2.4 in. (6.2 cm) to the left side of the chassis.

  • The optional rear cable management system (model number CBL-MGR-TXP-LCC) supports the TXP-T1600 configuration and fiber-optic array cables only (see Figure 1).

  • The LCC rear cable management system (model number CBL-MGR-TXP-3D-LCC) can be used for any configuration including TXP-T1600 configuration, TXP-T1600-3D configuration, TXP-T4000-3D configuration, and TXP-Mixed-LCC-3D configuration.

See the TX Matrix Plus Router Hardware Guide for instructions on installing and using the T1600 rear cable management system.

Figure 1: T1600 Rear Cable Management System
T1600 Rear Cable Management
System