Configuring Multipath (NSM Procedure)

You can configure protocol-independent load balancing for Layer 3 virtual private networks (VPNs) with load sharing among multiple external BGP paths and multiple internal BGP paths. You can use forwarding next hops for both the active route and alternative paths for load balancing.

To configure multipath load balancing in NSM:

  1. In the navigation tree, select Device Manager > Devices.
  2. In the Devices list, double-click the device to select it.
  3. Click the Configuration tab.
  4. In the configuration tree, expand Routing Options.
  5. Select Multipath.
  6. Enter the parameters as specified in Table 39.
  7. Click one:
    • OK—To save the changes.
    • Cancel—To cancel the modifications.
    • Apply—To apply the routing option settings.

Note: After you make changes to a device configuration, you must push that updated device configuration to the physical security device for those changes to take effect. You can update multiple devices at one time. See the Updating Devices section in the Network and Security Manager Administration Guide for more information.

Table 39: Configuring Multipath Fields

Option

Function

Your Action

Comment

Specifies the comment for the multipath configuration.

Enter the comment.

Vpn Unequal Cost

Applies protocol-independent load balancing to VPN routes.

  1. Expand the Multipath tree and select Vpn Unequal Cost.
  2. Enter the comment for the vpn unequal cost configuration and specify whether both external and internal BGP paths should be selected for the multipath configuration by selecting the Equal External Internal check box.