Configuring Static Routing

You can use the J-Web interface to configure static routes for the QFX Series.

To configure static routes:

  1. Select Configure > Routing > Static Routing. The Static Routing page displays details of the configured routes.

    Note: After you make changes to the configuration on this page, you must commit the changes for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes for details about all commit options.

  2. Click one:

    • Add—To configure a route. Enter information in the routing page as described in Table 19.
    • Edit—To modify an existing route. Enter information in the routing page as described in Table 19.
    • Delete—To delete an existing route.

Table 19: Static Routing Configuration Summary

Field

Function

Your Action

Default Route 

Default Route

Specifies the default gateway for the switch.

To specify an IPv4 address:

  1. Select IPv4.
  2. Type an IP address—for example, 10.10.10.10.
  3. Enter the subnet mask or address prefix. For example, 24 bits represents 255.255.255.0.
Static Routes 

Nexthop

Specifies the next-hop address or addresses to be used when routing traffic to the static route.

To add an address:

  1. Click Add.
  2. In the IP address text box, enter the IP address.

    Note: If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

  3. Click OK.

To delete a next-hop address, select it from the list and click Delete.

Related Documentation