Removing the SRE from the SRX650 Services Gateway

The SRE is located at the back panel of the chassis and can be installed in the horizontal slots labeled SRE0 or SRE1.0/1.1. The SRE weighs 3 lb, 13.6 oz (1.75 kg).

Caution: The SRE is not hot-swappable. You must power off the services gateway before removing or inserting an SRE.

To remove the SRE:

  1. Obtain an electrostatic bag to store the SRE after you remove it.
  2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
  3. Power off the services gateway.
  4. Use a number 2 Phillips screwdriver to loosen the captive screws on each side of the SRE.
  5. Grasp the locking levers on each side of the SRE and pull toward you to unlock the SRE (see Figure 25).
  6. Slide the SRE out and place it in the electrostatic bag.
  7. If you are not replacing the SRE, install a blank panel over the empty slot.

Figure 25: Removing the Services and Routing Engine (SRE)

Removing the Services and Routing
Engine (SRE)

Related Documentation