Removing the Fan Tray on the SRX650 Services Gateway

A single handle with two screws holds both the fan tray and air filter on the back of the services gateway. To remove the fan tray, you must also remove the air filter. See Figure 15.

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the side of the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX650 Services Gateway.
  2. Use a number 2 Phillips screwdriver to loosen and remove only the center screw of the handle.
  3. Grasp the fan tray handle and pull it out approximately 1 to 3 inches.

    Warning: To avoid injury, keep tools and your fingers away from the fans as you slide the fan tray out of the chassis. The fans might still be spinning.

  4. Press the latch located on the inside of the fan tray to release it from the chassis.
  5. Place one hand under the fan tray to support it and carefully slide the fan tray (and air filter) completely out of the chassis.

Figure 15: Removing the Fan Tray from the Services Gateway

Removing the Fan Tray
from the Services Gateway

Related Documentation