Hide Navigation Pane
Show Navigation Pane
Feedback
Download
SHA1
SRX5800 Services Gateway Services Processing Card LEDs
LEDs on the faceplate indicate the SPC status (see Table 11).
Table 11: SPC LEDs
Label | Color | State | Description |
|---|---|---|---|
OK/FAIL | Green | On steadily | SPC is functioning normally. |
Red | On steadily | SPC has failed. | |
STATUS | Off | Off | SPU is offline. If both SPUs are offline it is safe to remove the SPC from the chassis. |
Green | On steadily | SPU is operating normally. | |
Amber | On steadily | SPU is initializing. | |
Red | On steadily | SPU has an error or failure. | |
SERVICE | Off | Off | Service is not running on the SPU. |
Green | On steadily | Service is running on the SPU under acceptable load. | |
Amber | On steadily | Service on the SPU is overloaded. | |
HA | Green | On steadily | All cluster members and monitored links are available. |
Red | On steadily | A cluster member is missing or unreachable, or the other node is no longer part of a cluster because it has been disabled by the dual membership and detection recovery process in reaction to a control link or fabric link failure. | |
Amber | On steadily | All cluster members are present, but one or more monitored links are down. | |
Unlit | Off | The node is not configured for clustering or it has been disabled by the dual membership and detection recovery process in reaction to a control link or fabric link failure. | |
LINK/ACT | Green | On steadily | Chassis Cluster Control port link is active. |
Off | No link. | ||
ENABLE | Green | On steadily | The Chassis Cluster Control port is enabled. |
Off | The Chassis Cluster Control port is disabled. |
Two LEDs, located on the craft interface above the SPC, display the status of the SPC and are labeled OK and FAIL.
