Replacing the SRX5800 Services Gateway Cable Manager

To replace the cable manager, perform the following procedures:

  1. Removing the SRX5800 Services Gateway Cable Manager
  2. Installing the SRX5800 Services Gateway Cable Manager

Removing the SRX5800 Services Gateway Cable Manager

To remove the cable manager (see Figure 93):

  1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Using a 7/16-in. nut driver, unscrew the nuts on the corners of the cable manager.
  3. Grasp the bottom of the cable manager and pull it straight out from the studs on the front of the chassis.

Figure 93: Removing the Cable Manager

Removing the Cable Manager

Installing the SRX5800 Services Gateway Cable Manager

To install the cable manager (see Figure 94):

  1. Position the standard cable manager on the studs on the lower front of the chassis.
  2. Insert the nuts on the corners in the standard cable manager onto the studs on the chassis.
  3. Using a 7/16-in. nut driver, tighten the nuts securely.

Figure 94: Installing the Cable Manager

Installing the Cable Manager