Replacing the SRX5600 Services Gateway Cable Manager

To replace the cable manager, perform the following procedures:

  1. Removing the SRX5600 Services Gateway Cable Manager
  2. Installing the SRX5600 Services Gateway Cable Manager

Removing the SRX5600 Services Gateway Cable Manager

The cable management system is located on both sides of the card cage. The cable management system weighs approximately 0.3 lb (0.14 kg).

To remove the cable management system (see Figure 71):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Loosen the captive screws on either side of the chassis.
  3. Remove the cable manager.

Figure 71: Removing or Installing the Cable Management System

Image g030240.gif

Installing the SRX5600 Services Gateway Cable Manager

To install the cable management system:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Position the cable management system on the front sides of the chassis.
  3. Insert the tabs into the slots.
  4. Tighten the captive screws completely.