Replacing the SRX5600 Services Gateway Fan Tray

To replace a fan tray, perform the following procedures in sequence:

  1. Removing the SRX5600 Services Gateway Fan Tray
  2. Installing the SRX5600 Services Gateway Fan Tray

Removing the SRX5600 Services Gateway Fan Tray

Note: To prevent overheating, install the replacement fan tray immediately after removing the existing fan tray.

To remove the fan tray (see Figure 43):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Loosen the captive screws on the fan tray faceplate.
  3. Grasp the fan tray handle and pull it out approximately 1 to 3 inches.

    Warning: To avoid injury, keep tools and your fingers away from the fans as you slide the fan tray out of the chassis. The fans might still be spinning.

  4. Press the latch located on the inside of the fan tray to release it from the chassis.
  5. Place one hand under the fan tray to support it and pull the fan tray completely out of the chassis.

Figure 43: Removing the Fan Tray

Image g004225.gif

Installing the SRX5600 Services Gateway Fan Tray

To install the fan tray (see Figure 44):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Grasp the fan tray handle and insert it straight into the chassis. Note the correct orientation by the this side up label on the top surface of the fan tray.
  3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.

Figure 44: Installing the Fan Tray

Image g004226.gif