Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet

The services gateway can be installed in a four-post rack or cabinet or an open-frame rack. Install the mounting hardware on the rack before installing the services gateway.

Install the mounting shelf, which is included in the shipping container, before installing the services gateway. We recommend that you install the mounting shelf because the weight of a fully loaded chassis can be up to 163.5 lb (74.2 kg).

Table 25 specifies the holes in which you insert cage nuts and screws to install the mounting hardware required. The hole distances are relative to one of the standard U divisions on the rack. The bottom of all mounting shelves is at 0.02 in. above a U division.

Table 25: Four-Post Rack or Cabinet Mounting Hole Locations

Hole

Distance Above U Division

3

1.51 in. (3.8 cm)

0.86 U

2

0.88 in. (2.2 cm)

0.50 U

1

0.25 in. (0.6 cm)

0.14 U

To install the mounting shelf on the front rails of a four-post rack or cabinet, or the rails of an open-frame rack (see Figure 23 or Figure 24):

  1. If needed, install cage nuts in the holes specified in Table 25.
  2. On the back of each rack rail, partially insert a mounting screw into the lowest hole specified in Table 25.
  3. Install the mounting shelf on the back of the rack rails. Rest the bottom slot of each flange on a mounting screw.
  4. Partially insert the remaining screws into the open holes in each flange of the mounting shelf.
  5. Tighten all the screws completely.

Figure 23: Installing the Front Mounting Hardware for a Four-Post Rack or Cabinet

Image g004257.gif

Figure 24: Installing the Mounting Hardware for an Open-Frame Rack

Image g004255.gif

Related Documentation