Installing or Replacing the Air Filter on the SRX550 Services Gateway

The SRX550 Services Gateway has provision for an optional air filter that installs vertically in the rear of the chassis on the right side. The air filter weighs 2.2 oz (62.37 grams) and is hot-swappable. The air filter is required for NEBS compliance.

Note: The SRX550 Services Gateway does not ship with an air filter. An air filter must be purchased separately.

Note: You can install or replace the air filter while the services gateway is running.

To install or replace the air filter:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX550 Services Gateway.
  2. Use a Phillips (+) screwdriver, number 1 to loosen both captive screws on the air filter cover (see Figure 23).
  3. Carefully remove the air filter cover.

    Figure 23: Removing the Air Filter Cover

    Removing the Air Filter
Cover
  4. If you are replacing an existing air filter, remove the air filter tray, as shown in Figure 24.

    Figure 24: Removing the Air Filter

    Removing the Air Filter
  5. Orient the new air filter, as shown in Figure 25 and slide it straight into the chassis until it stops.

    Figure 25: Installing the Air Filter

    Installing the Air Filter
  6. Align the captive screws of the cover with the mounting holes on the chassis.
  7. Use a Phillips (+) screwdriver, number 1 to tighten both captive screws on the handle, as shown in Figure 26.

    Figure 26: Installing the Air Filter Cover

    Installing the Air Filter
Cover

Related Documentation