Removing Components from the Chassis for Manual Lifting of the SRX3600 Services Gateway

To make the services gateway light enough to install manually, you first remove the following components from the chassis, as shown in Figure 28 and Figure 29:

The procedure in this section for removing components from the chassis is for initial installation only, and assumes that you have not connected power cables to the services gateway.

Figure 28: Components to Remove from the Front of the Services Gateway

Image g030265.gif

Figure 29: Components to Remove from the Rear of the Services Gateway

Image g030266.gif

To remove the components from the services gateway:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX3600 Services Gateway.
  2. If you have not already done so, power off the services gateway by pressing the Power button on the front panel of the Switch Fabric Board (SFB) for three to five seconds. The PWR LED blinks to show you that the services gateway is shutting down. Wait for the services gateway to shut down before proceeding.
  3. Release each component by loosening its retaining screws and unlatching its ejector handles as appropriate.
  4. Slide each component out of the chassis evenly so that it does not become stuck or damaged.
  5. Label each component as you remove it so you can reinstall it in the correct location.
  6. Immediately store each removed component in an electrostatic bag.
  7. Do not stack removed components. Lay each one on a flat surface.

Related Documentation