Removing the Battery from the Routing Engine of an SRX3400 Services Gateway for Recycling

The Routing Engine installed in the services gateway contains a CR2032 .3.0-volt lithium battery. The coin-shaped battery is approximately 3/4 in. (19 mm) in diameter. The battery is estimated to last for over 50 years.

Before recycling a Routing Engine or the services gateway chassis, remove the battery from the Routing Engine for recycling.

Before you begin to remove the battery:

The Routing Engine is located in the rear slot labeled RE0 on the services gateway. To remove the battery from a Routing Engine in the services gateway (see Figure 89), perform the following steps:

  1. Attach the ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Remove the Routing Engine, as described in Replacing a Routing Engine on the SRX3400 Services Gateway.
  3. Locate the coin-shaped CR2032 battery on the left side of the Routing Engine (see Figure 89).
  4. Remove the battery from its socket.
  5. Recycle the battery as required.

Figure 89: Location of CR2032 Battery in a Routing Engine

Image g036101.gif

Related Documentation