The Network Processing Card (NPC) is installed in the rear of the Services Gateway in slot 5, 6, or 7. Before you replace an NPC, you must power off the Services Gateway.
To replace an NPC:
The PWR LED blinks to show you that the device is shutting down. Wait for the device to shut down before proceeding.
Figure 52: Removing an NPC
Figure 53: Installing an NPC
![]() |
Note: If the OK/FAIL LED is red, remove and reinstall the Routing Engine. If the OK/FAIL LED remains red, the Routing Engine is not functioning properly. Contact your customer support representative. |
![]() |
Warning: Never lift the Services Gateway using the handles on the front panels of the NPCs or other CFM cards. The handles might come off, causing the chassis to drop and inflicting possible grave injury. |