Installing the SRX220 Services Gateway on a Wall

You can install the SRX220 Services Gateway on a wall.

Note: The wall-mounting kit is not shipped with the device and must be ordered separately.

To install the device on a wall:

  1. Place the device on a flat and level surface with the Juniper Networks logo embossed on the top cover facing up. Ensure that the rubber feet are attached to the bottom of the chassis.
  2. Position a mounting bracket on each side of the chassis, as shown in Figure 12.

    Figure 12: SRX220 Services Gateway Wall Installation — Attaching the Mounting Brackets

    Image g037609.gif

    Table 23 lists the parts used for installing the SRX220 Services Gateway on a wall. The numbers in Figure 12 correspond to the numbers in Table 23.

    Table 23: SRX220 Services Gateway Wall Installation Parts

    Number

    Part

    Quantity

    1

    Mounting bracket

    2

    2

    Screw

    8

  3. Use a number-1 Phillips screwdriver to install the screws that secure the mounting brackets to the chassis.
  4. If you are using wall anchors to support the chassis, install two pairs of anchors on the wall, spaced apart equal to the width of chassis with mounting brackets attached.
  5. Have one person grasp the sides of the device, lift it, and position it on the wall.
  6. Have a second person install two pairs of mounting screws through the bracket holes on either side of the device to secure it to the wall.
  7. Verify that the mounting screws on one side are aligned with the mounting screws on the opposite side and that the device is level (see Figure 13).

Figure 13: SRX220 Services Gateway Wall Installation — Hanging the Services Gateway on a Wall

Image g037610.gif

Related Documentation