Troubleshooting the Network and Services Processing Card on the SRX1400 Services Gateway

To troubleshoot the Network and Services Processing Card (NSPC), follow these guidelines:

Make sure the NSPC is properly seated in the slot and its screws are tightened.
Use the CLI show chassis fpc 1 command to check the status of installed NSPC. As shown in the sample output for show chassis fpc 1, the value Online in the column labeled State indicates that the NSPC is functioning normally:
user@host> show chassis fpc 1
```
                     Temp  CPU Utilization (%)   Memory    Utilization (%)
Slot State            (C)  Total  Interrupt      DRAM (MB) Heap     Buffer
  1  Online            34     40          0       1024        3         27
```
Note: Because the NSPC occupies slot 1 and slot 3 of the SRX1400 Services Gateway chassis, you can use the show chassis fpc 1 and show chassis fpc 3 commands to check the status of NSPC.

Use the CLI show chassis fpc 1 detail command for more detailed output.

user@host> show chassis fpc 1 detail

Slot 1 information:
  State                                 Online
  Temperature                        34 degrees C / 93 degrees F
  Total CPU DRAM                   1024 MB
  Total RLDRAM                        0 MB
  Total DDR DRAM                      0 MB
  Start time:                           2010-07-08 13:56:24 UTC
  Uptime:                               5 days, 20 hours, 22 minutes, 7 seconds
  Max Power Consumption               0 Watts

For further descriptions of the output from the commands, see the Junos System Basics and Services Command Reference.

Troubleshooting the Network and Services Processing Card on the SRX1400 Services Gateway

Related Documentation