Troubleshooting Network Processing Cards on the SRX1400 Services Gateway

To troubleshoot an NPC, follow these guidelines:

• Make sure the NPC is properly seated in the slot and its screws are tightened.
• Make sure that the double wide tray holder is properly installed in the slot.
• Use the CLI show chassis fpc 3 command with the slot number to check the status of installed NPC.

  As shown in the sample output, the value Online in the column labeled State indicates that the NPC is functioning normally:

  
  

  user@host> show chassis fpc 3

                       Temp  CPU Utilization (%)   Memory    Utilization (%)
  Slot State            (C)  Total  Interrupt      DRAM (MB) Heap     Buffer
    3  Online            54     40          0       1024        3         27

• Use the CLI show chassis fpc 3 detail command for more detailed output.
  
  

  user@host> show chassis fpc 3 detail

  Slot 3 information:
    State                                 Online
    Temperature                        54 degrees C / 129 degrees F
    Total CPU DRAM                   1024 MB
    Total RLDRAM                        0 MB
    Total DDR DRAM                      0 MB
    Start time:                           2010-07-08 13:56:19 UTC
    Uptime:                               5 days, 20 hours, 34 minutes, 56 seconds
    Max Power Consumption               0 Watts

For further descriptions of the output from the commands, see the Junos System Basics and Services Command Reference.

Related Documentation

• Network Processing Cards
• Replacing a Network Processing Card on the SRX1400 Services Gateway
• SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway