Removing Components from the Chassis for Manual Lifting of the SRX1400 Services Gateway

To make the services gateway light enough to install manually, you must first remove the following components from the chassis:

The procedure in this topic is for removing components from the base model of the chassis for initial installation only. To use this procedure, you must have not yet connected power cables to the services gateway.

To remove the components from the device:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see the SRX1400 Services Gateway Hardware Documentation.
  2. Release each component by loosening its retaining screws and unlatching its ejector handles as appropriate.
  3. Slide each component out of the chassis evenly so that it does not become stuck or damaged.
  4. Label each component as you remove it so you can reinstall it in the correct location.
  5. Immediately store each removed component in an electrostatic bag.
  6. Do not stack removed components. Set each one on a flat surface.

Related Documentation