2-Port XFP 10-Gigabit Ethernet I/O Card

The SRX3K-2XGE-XFP adds two ports for 10-gigabit Ethernet traffic from fiber interface media. To use fiber interface media, install 10-gigabit small form-factor pluggable (XFP) transceivers on the desired ports.

Figure 14 shows the 2-Port XFP 10-Gigabit Ethernet IOC. Ports are numbered from left to right, 0 through 1.

Figure 14: 2-Port XFP 10-Gigabit Ethernet I/O Card

2-Port XFP 10-Gigabit Ethernet
I/O Card
  • If a CFM slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the device.
  • The ONLINE button on the IOC does not perform any function and is currently not supported.

LEDs on the faceplate of the IOC indicate port status and connectivity. Table 23 describes the 2-Port XFP 10-Gigabit Ethernet IOC LEDs.

Table 23: LED Indicators on the 2-Port XFP 10-Gigabit Ethernet I/O Card

Label

Color

Status

Indicated Behavior

SERVICE

Green

On steadily

The IOC is mapped to the Network and Service Processing Card (NSPC) and is available to carry Ethernet traffic.

Amber

On steadily

The IOC is not mapped to the NSPC and is not available to carry Ethernet traffic.

Unlit

Off

The IOC is administratively disabled but is mapped to the NSPC.

OK/FAIL

Green

On steadily

The IOC is operating normally.

Green

Blinking

The IOC is preparing for a hot-swappable event:

  • IOC is being Inserted: power up, booting, initialization.
  • IOC is being removed: shut down by chassis management software.

Red

On steadily

The IOC has failed and is not operating normally.

Unlit

Off

The IOC is offline and can be safely removed.

Related Documentation