16-Port SFP Gigabit Ethernet I/O Card

The SRX3K-16GE-SFP adds 16 ports for Gigabit Ethernet traffic from either copper or fiber interface media.

To use fiber or copper interface media, install small form-factor pluggable (SFP) transceivers on the desired ports.

Note: We strongly recommend the use of Juniper Networks SFP and XFP transceivers. We cannot guarantee correct operation if other transceivers are used. The transceiver type can be different in each port, as long as a Juniper Networks transceiver is used.

Figure 13 shows the 16-Port SFP Gigabit Ethernet IOC. Ports are numbered from top to bottom and left to right, 0 through 15.

Figure 13: 16-Port SFP Gigabit Ethernet I/O Card

16-Port SFP Gigabit Ethernet I/O
Card
  • If a CFM slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the device.
  • ONLINE button on the IOC does not perform any function and is currently not supported.

LEDs on the faceplate of the IOC indicate port status and connectivity. Table 22 describes the 16-Port SFP Gigabit Ethernet IOC LEDs.

Table 22: LED Indicators on the 16-Port SFP Gigabit Ethernet I/O Card

Label

Color

Status

Indicated Behavior

SERVICE

Green

On steadily

The IOC is mapped to the Network and Service Processing Card (NSPC) and is available to carry Ethernet traffic.

Amber

On steadily

The IOC is not mapped to the NSPC and is not available to carry Ethernet traffic.

Unlit

Off

The IOC is administratively disabled but is mapped to the NSPC.

OK/FAIL

Green

On steadily

The IOC is operating normally.

Green

Blinking

The IOC is preparing for a hot-swappable event:

  • Card is being Inserted: power up, booting, initialization.
  • Card is being removed: shut down by chassis management software.

Red

On steadily

The IOC has failed and is not operating normally.

Unlit

Off

The IOC is offline and can be safely removed.

Related Documentation