Verifying Parts Received with the SRX1400 Services Gateway

A packing list is included in each shipment. Check the parts in the shipment against the items on the packing list. The packing list specifies the part numbers and descriptions of each part in your order. Note that feature and service cards are shipped in separate boxes from the chassis.

If any part is missing, contact a customer service representative.

A fully configured services gateway contains the chassis with installed components, listed in Table 30, and an accessory box, which contains the parts listed in Table 31. The parts shipped with your device can vary depending on the configuration you ordered.

Table 30: Parts List for a Fully Configured SRX1400 Services Gateway

Component

Quantity

Chassis, including backplane, and rack-mounting brackets

1

NSPC

1

Routing Engine

1

System I/O card

1

Power supplies

At least 1 and up to 2

Fan tray

1

Air filter

1

SRX1400 Services Gateway Getting Started Guide

1

Blank panels for slots without components installed

  • 1 single-wide blank panel for the slot not occupied by an IOC
  • 1 dual-wide blank panel for NSPC slot not occupied by an NSPC.

AC Power Cord

1

Note: The NSPC and IOC are not a part of the base chassis configuration. You must order them separately. Contact your Juniper Networks customer service representative for more information.

Note: If you are planning to use Network Processing Card (NPC) and Services Processing Card (SPC) (supported on SRX3000 Series Services Gateway) on the SRX1400 device, then you must order them separately. For more details on NPC and SPC, see SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway.

You can use NPC and SPC on the SRX1400 device in place of the NSPC.

To install the NPC and SPC on the SRX1400 Services Gateway, you must order the double wide tray holder (SRX1K3K-2CFM-TRAY) to hold two single-wide CFMs (NPC and SPC) separately. Contact your Juniper Networks customer service representative for more information.

Table 31: Accessory Box Parts List

Part

Quantity

Rack mount kit

1

RJ-45-to-DB-9 cable to connect the device through the serial port

1

Juniper Networks Product Warranty

1

End User License Agreement

1

SRX1400 Services Gateway Getting Started Guide

1

Documentation Information Card

1

Product Registration

1

Juniper Compliance Form Letter; Reduction of Hazardous Substances (RoHS)

1

Document sleeve

1

ESD wrist strap with cable

1

Related Documentation