16-Port SFP Gigabit Ethernet I/O Card

The SRX3K-16GE-SFP adds 16 ports for Gigabit Ethernet traffic from either copper or fiber interface media.

To use fiber or copper interface media, install small form-factor pluggable (SFP) transceivers on the desired ports.

Note: We strongly recommend the use of Juniper Networks SFP and XFP transceivers. We cannot guarantee correct operation if other transceivers are used. The transceiver type can be different in each port, as long as a Juniper Networks transceiver is used.

Figure 12 shows the 16-Port SFP Gigabit Ethernet IOC. Ports are numbered from top to bottom and left to right, 0-15.

Figure 12: 16-Port SFP Gigabit Ethernet I/O Card

If a CFM slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the device.
The ONLINE button on IOC does not perform any function and currently it is not supported.

LEDs on the faceplate of the IOC indicate port status and connectivity. Table 22 describes the 16-Port SFP Gigabit Ethernet IOC LEDs.

Table 22: LED Indicators on the 16-Port SFP Gigabit Ethernet I/O Card

Label	Color	Status	Indicated Behavior
SERVICE	Green	On steadily	The IOC is mapped to the Network and Service Processing Card (NSPC) and is available to carry Ethernet traffic.
	Amber	On steadily	The IOC is not mapped to the NSPC and is not available to carry Ethernet traffic.
	Dark (unlit)	Off	The IOC is administratively disabled but is mapped to the NSPC.
OK/FAIL	Green	On steadily	The IOC is operating normally.
	Green	Blinking	The IOC is preparing for an online insertion and removal event: Card is being Inserted: power up, booting, initialization. Card is being removed: shut down by chassis management software.
	Red	On steadily	The IOC has failed and is not operating normally.
	Dark (unlit)	Off	The IOC is offline and can be safely removed.

16-Port SFP Gigabit Ethernet I/O Card

Related Documentation